Setra Systems Power Meter
- Can I use my existing CTs from the old meter?
- Do I have to use SETRA Rogowski coils?
- Does the power meter have an on-board termination resistor?
- Is the meter BTL certified?
- What’s the power meter’s BACnet load?
- How do I mount the meter?
- How far can I run wires to CTs?
- Do I have to group the CTs in consecutive spots on the meter?
- When I clone the set up on the meter, does the pass code get cloned?
- Can I perform harmonic analysis using the power meter?
- What happens if I forget my pass code?
- Can I use 5A CTs?
- How do I update the meter to the most recent version of software?
- Will the time stamp adjust for Daylight Savings Time?
- What does DEADBAND mean on the Alarm settings?
- Can the display be mounted remotely?
- What baud rates will the meter support?
- Do I need a separate enclosure for the meter?
- Is the meter compliant to the California IoT initiative?
- When I setup the unit for communication on BACnet, will the meter accept those configuration settings automatically or will I have to power cycle the meter?